对于济南卷帘门我们要小心呵护,就好像呵护我们自己一样,这样才能够延长卷帘门的寿命,才能够提高卷帘门的可用性。下面就由小编告诉你正确的卷帘门保养方法吧:

　　We need to take good care of Jinan roller shutter doors, just like taking care of ourselves, in order to extend their lifespan and improve their usability. Let me tell you the correct maintenance method for rolling shutter doors:

　　1、卷帘门安装位置的上端应有可靠的防火设施,在卷帘门的卷筒下端做包箱或吊顶时必须设置可拆式活动盖板,在卷帘门弹王下端必须预留500x500mm可拆检修孔,以便于维修保养。

　　1. The upper end of the installation position of the rolling shutter door should have reliable fire prevention facilities. When making a package box or ceiling at the lower end of the rolling shutter door, a detachable movable cover plate must be installed. A 500x500mm detachable access hole must be reserved at the lower end of the rolling shutter door spring to facilitate maintenance.

　　2、卷帘门运行时如有发生较大抖动或异常声音时应停机检查,排除有碍门帘正常启闭的杂物。

　　2. If there is significant shaking or abnormal noise during the operation of the rolling shutter door, the machine should be stopped for inspection to eliminate any debris that may hinder the normal opening and closing of the door curtain.

　　3、闸门门帘和易锈部位,应进行定期防腐、油漆及保养处理,禁止用重物、硬物冲击门面。

　　3. Gate curtains and rust prone areas should undergo regular anti-corrosion, painting, and maintenance treatment. It is prohibited to use heavy or hard objects to impact the facade.

　　4、卷帘门底梁座上限位置必须与轴承架下端保持大于200mm的距离,以制动停止时不发生冲顶现象。

　　4. The upper limit position of the bottom beam seat of the rolling shutter door must be kept at a distance of more than 200mm from the lower end of the bearing frame to prevent the phenomenon of toppling when braking stops.

　　5、卷帘门在启闭停止过程中,应具备随位停止之功能,不应有停止而继续下滑现象,如发生下滑距离大于50mm的情况出现,应立即对卷帘门控制电器和卷门机制动器进行仔细检查修理,运行正常为止。

　　5. During the opening and closing process of the rolling shutter door, it should have the function of stopping according to the position, and there should be no further sliding phenomenon after stopping. If the sliding distance exceeds 50mm, the control electrical appliances and rolling shutter mechanism actuators of the rolling shutter door should be carefully inspected and repaired immediately, and normal operation should be stopped.

　　6、卷门机在运行、滑行、传动等部位应定期检查(少每年3次),并根据需要及时加油,以卷帘门的正常使用。

　　6. The rolling door machine should be regularly inspected (at least 3 times a year) during operation, sliding, transmission, and other parts, and refueled as needed to ensure the normal use of the rolling door.

　　7、卷帘门操作时,操作者必须站在能看到卷门运行状态的位置进行操作,否则易发生意外而受损。

　　7. When operating the rolling shutter door, the operator must stand in a position where the operating status of the rolling shutter door can be seen, otherwise accidents may occur and damage may occur.

　　8、所有电动控制的卷帘门,启闭运行方向必须与开关精指示相同,特别是在新接通电源试车或外来输入电源变换相线时,应先使用手动装置将门帘置于门洞高度1/2的位置,接通电源后试操作卷门启闭,直到与指示相附,方可正常使用,否则损坏限位器,引起卷帝反卷或冲中顶等而造成损失。

　　8. All electrically controlled rolling shutter doors must operate in the same direction as indicated by the switch, especially when testing with a new power supply or when changing the phase line of an external input power supply. The door curtain should be manually placed at half the height of the door opening, and the power supply should be turned on before attempting to open and close the rolling shutter door until it matches the indication before it can be used normally. Otherwise, the limiter may be damaged, causing the roller to roll back or hit the center top, resulting in losses.

　　9、卷帘门门帘和卷门机禁止与酸、碱性物溶液接触,以防腐蚀门帘表面。

　　9. Roller shutter door curtains and door rolling machines must not come into contact with acidic or alkaline solutions to prevent corrosion of the door curtain surface.

　　本文由  济南卷帘门 友情奉献.更多有关的知识请点击  http://www.jnzxmy.com/   真诚的态度.为您提供为的服务.更多有关的知识我们将会陆续向大家奉献.敬请期待.

　　This article is a friendly contribution from Jinan Rolling Shutter Doors For more related knowledge, please click http://www.jnzxmy.com/ Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.