济南富强门业有限公司
联系人:林经理
电话:151 6888 2846
邮箱:527800164@qq.com
地址:济南市历下区化纤厂路8号3号楼101号
保温卷帘门安装方法
保温卷帘门是一种带有特殊功能的卷帘门,其主要特点是保温性能尤其出色。保温卷帘门采用铝合金或镀锌钢板双层一次辊轧成型,型材中间填充绿色发泡材料,能够有效噪音,提高型材的抗弯性,具有良好的保温效果。
Thermal insulation roller shutter door is a type of roller shutter door with special functions, which is characterized by particularly excellent thermal insulation performance. The insulation roller shutter door is formed by double layer rolling of aluminum alloy or galvanized steel plate, and the middle of the profile is filled with green and environmentally friendly foam material, which can effectively eliminate noise, improve the bending resistance of the profile, and have a good insulation effect.
保温卷帘门型材表面为多层烤漆或薄膜层,抗阳光照射、抗雨水、抗腐蚀、抗划伤。可采用外装、内装、中装多种安装方式,遇微碰撞后可反弹恢复,如划伤可做到单片更换。采用管状式电机配套安装,体积小、造型美观。
The surface of the insulated roller shutter door profile is made of multiple layers of baking paint or film, which is resistant to sunlight, rain, corrosion, and scratches. Multiple installation methods can be used, including exterior, interior, and interior. In the event of minor collisions, it can rebound and recover. If there are scratches, it can be replaced as a single piece. Equipped with a tubular motor for installation, it has a small volume and beautiful appearance.
保温卷帘门安装方法:
Installation method for insulation roller shutter door:
1、在安装的门框框口画线标出相应的位置,同时注明尺寸大小,需要注意的是框内高度要比门扇的高度高一些。安装在门外侧的保温卷帘门通常能使该门的K值少提高45%,在安装时保证卷帘面板与门框的间距≥40mm。
1. Draw lines and mark the corresponding positions at the mouth of the installed door frame, while indicating the size. It should be noted that the height inside the frame should be higher than the height of the door leaf. The insulation roller shutter door installed on the outside of the door can usually increase the K value of the door by at least 45%, and ensure that the distance between the roller shutter panel and the door frame is ≥ 40mm during installation.
2、为了将保温卷帘门的门框固定,要先拆掉门框下部的固定板,在洞口两侧的地面要事先预留凹槽,然后进行校正,待合格后固定木楔,将门框铁脚与预埋铁板件焊牢。
2. In order to fix the door frame of the insulated rolling shutter door, the fixing plate at the bottom of the door frame should be removed first. Grooves should be reserved on the ground on both sides of the opening in advance, and then corrected. After passing the inspection, wooden wedges should be fixed, and the iron feet of the door frame should be welded firmly with the embedded iron plate.
3、安装门扇主体,注意一定要保证保温卷帘门与墙体结成整体,封闭性要做好,然后粉刷洞口及墙体。粉刷完毕后,门缝应均匀平整,开启保温卷帘门应该自由轻便,不得有过紧、过松和反弹现象。
3. When installing the main body of the door leaf, be sure to ensure that the insulation roller shutter door is integrated with the wall, and the sealing should be done well. Then, paint the openings and walls. After the painting is completed, the door seam should be even and flat, and the insulation roller shutter door should be opened freely and lightly without any tightness, looseness, or rebound.
保温卷帘门安装要点:
Key points for installing insulation roller shutter doors:
(1)保证保温卷帘门在关闭时的密封性,座条必须与接触面密闭,通常可以在其下端设置一条弹性密封型材。
(1) To ensure the sealing of the insulation roller shutter door when closed, the seat strip must be sealed with the contact surface, and an elastic sealing profile can usually be set at its lower end.
(2)导轨上必须有密封装置,有弹性的橡胶条或者硅化毛条,加有密封装置的导轨的宽度须与叶片的厚度相适应。
(2) There must be a sealing device on the guide rail, with elastic rubber strips or silicified wool strips. The width of the guide rail with a sealing device must match the thickness of the blades.
(3)为了减少从卷帘门包箱口生产的热量损失,必须使处于关闭状态的卷帘板压住卷帘包箱的外侧面,必要时在相应缝隙处加装密封条。
(3) In order to reduce the heat loss produced from the opening of the rolling shutter door packaging box, it is necessary to press the closed rolling shutter board against the outer side of the rolling shutter packaging box, and if necessary, install sealing strips at the corresponding gaps.
(4)为了符合减少构件热损失的要求,需要在暗装卷帘包箱朝寅一面加上厚度在20mm以上的保温材料,缝隙处可用如密封条等密封。
(4) In order to meet the requirements of reducing component heat loss, it is necessary to add insulation material with a thickness of 20mm or more on the inward side of the concealed roller shutter packaging box, and the gaps can be sealed with sealing strips.
本文由济南卷帘门友情奉献.更多有关的知识请点击:http://www.jnzxmy.com真诚的态度.为您提供为的服务.更多有关的知识我们将会陆续向大家奉献.敬请期待.
This article is dedicated by Jinan Roller Shutter Door. For more information, please click: http://www.jnzxmy.com Sincere attitude. We will provide you with comprehensive service. We will gradually contribute more relevant knowledge to everyone. Stay tuned
阅读/ Recommended reading
- 重视卷帘门门口堆物问题 2024-11-06
- 快速卷帘门介绍与快速卷帘门材料说明 2024-10-26
- 济南卷帘门厂:卷帘门安装施工工艺详解 2024-10-14
- 济南卷帘门安装秘籍,让家居更有面子 2024-09-21
- 济南遥控卷帘门:我来教你——卷闸门遥控器遇到故障怎么办? 2024-08-28
- 济南卷帘门:卷帘门(不锈钢款) 2024-07-25
- 济南卷帘门的故障维修与更换卷帘门注意事项 2024-07-19
- 选错济南卷帘门的后果居然有这么严重? 2024-07-13
铝合金原料的卷帘门日常保养影响着其运用寿命,下面在教你10个诀窍,保证电动卷帘门在运用过程中更顺利,运用寿命更长。 The daily maintenance of alum...